Kellfri 13-VT250, Руководство по эксплуатации

Страница: 7 / 28

7
Table of contents
MAINTENANCE AND SERVICE
• Make sure that the equipment is stable and cannot tip over when carrying out mainte-
nance and service work.
• Replace damaged or worn parts to reduce the risk of injuries.
• Carry out maintenance, service and checks in line with recommendations.
• Only use spare parts with equal performance to reduce the risk of injuries and break-
downs.
• All electrical repairs and electrical connections must be carried out by a qualified person.
Check that all nuts and bolts are tightened after maintenance and service work.
Always test the firewood conveyor before starting work.
IMPORTANT!
Avoid over-lubricating. Dirt collects easily on exposed grease and causes increased wear.
After lubrication, wipe off all excess grease.
TRANSPORTATION AND SET-UP
• Check that the work area is free from bystanders, children and objects before driving off.
• Always observe additional caution during transport and moving.
• Ensure that the equipment or product is well anchored and that available transport lash-
ings are fitted.
• Always position the load as low as possible. All protruding loads should be well anchored.
• Respect the risk zones even during transport and moving.
• Do not permit anyone to walk under suspended loads when carrying out lifts.
• Trailers used for transport should have brakes that work.
• An SMV sign must be attached when travelling on public roads.
• Check tyre pressure - see information on the sidewalls of the tyres. Do not exceed the
maximum pressure!
• Always store the equipment or product in a dry place, preferably under a roof, when not
in use.
• Ensure that the equipment or product is stable and cannot tip over.
• Never permit children to play at the storage site.
• Be aware of the tipping risk!
RECYCLING
For scrapping, the equipment/product must be dismantled and transported to a
recycling station designated by your local authority. Contact your local authority
for further information.
Kellfri AB has a policy of continuous product development and therefore reserves the right to
make modifications, e.g. to the design and appearance of the product, without prior notice.