- 10 - www.keller-druck.com
“Pressure Switch Console” Software
If the programmer is connected to a PC / laptop via a interface cable (K-107 / K-104
B), the configuration of the pressure switch can easily be made with the “Pressure
Switch Console” program.
Setting the serial port
The serial connection that is used to
connect the programmer to the PC / laptop
must be entered under Edit / Port. If no COM
numbers are listed, the connection must be
set with „Set COMPort“.
Selection of the pressure measuring unit
The pressure unit (bar, PSI or MPa), in
which the program displays the pressure
values, can be selected.
Read-out and programming of the pressure switch
By pressing “Read out”, the data of the pressure switch, which is connected to the
programmer, is read. The configurations (switching thresholds, switching functions,
switching time delays) can now be changed for the switch outputs 1 and 2.
Press “Program” to load the changed values back to the pressure switch. Due to
the reduced resolution of the pressure switch, the pressure values displayed may
change slightly. The nearest possible value is set.
When programming is complete, the pressure switch can be disconnected and used:
the configuration in the pressure switch remains stored.
