![background image](http://html2.mh-extra.com/html/keithley/sourcemeter-2600b-series/sourcemeter-2600b-series_reference-manual_4085220697.webp)
Section 7: TSP command reference
Series 2600B System SourceMeter® Instrument Reference Manual
7-358
2600BS-901-01 Rev. C / August 2016
Performs a linear current sweep with voltage measured at every step (point):
1. Sets the
smu
to output
starti
amperes, allows the source to settle for
stime
seconds, and then
performs a voltage measurement.
2. Sets the
smu
to output the next amperes step, allows the source to settle for
stime
seconds, and then
performs a voltage measurement.
3. Repeats the above sequence until the voltage is measured on the
stopi
amperes step.
The linear step size is automatically calculated as follows:
step = (stopi – starti) / (points – 1)
Figure 134: SweepILinMeasureV()
Example
SweepILinMeasureV(smua, -1E-3, 1E-3, 0, 100)
This function performs a 100-point linear current
sweep starting at
−
1 mA and stopping at
+
1 mA.
Voltage is measured at every step (point) in the
sweep. Because
stime
is set for 0 s, voltage is
measured as quickly as possible after each
current step.
Also see
SweepIListMeasureV()
This KISweep factory script function performs a current list sweep with voltage measured at every step (point).
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
No
Usage
SweepIListMeasureV(
smu, ilist, stime, points
)
smu
System SourceMeter
®
instrument channel (for example,
smua
refers to SMU
channel A)
ilist
Arbitrary list of current source values;
ilist = {value1, value2,
...valueN}
stime
Settling time in seconds; occurs after stepping the source and before performing a
measurement
points
Number of sweep points (must be
≥
2)