![background image](http://html2.mh-extra.com/html/keithley/sourcemeter-2600b-series/sourcemeter-2600b-series_reference-manual_4085220559.webp)
Section 7: TSP command reference
Series 2600B System SourceMeter® Instrument Reference Manual
7-220
2600BS-901-01 Rev. C / August 2016
Details
This attribute sets the size of the stack used for filtered measurements.
Example
smua.measure.filter.count = 10
Sets the filter count for SMU channel A to 10.
Also see
(on page 3-3)
(on page 7-173)
(on page 7-194)
(on page 7-232)
smuX.measure.filter.enable
This command enables or disables filtered measurements.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
Instrument reset
SMU reset
Recall setup
Saved setup
0 (smuX.FILTER_OFF)
Usage
filterState
= smu
X
.measure.filter.enable
smu
X
.measure.filter.enable =
filterState
filterState
The filter status; set to one of the following values:
0
or
smu
X
.FILTER_OFF
: Disables the filter
1
or
smu
X
.FILTER_ON
: Enables the filter
X
SMU channel (for example,
smua.measure.filter.enable
applies to SMU
channel A)
Details
This command enables or disables the filter.
Example
smua.measure.filter.enable = 1
Enables the filter for SMU channel A. Alternatively, the
value 1 may be replaced with
smua.FILTER_ON
.
Also see
(on page 3-3)
(on page 7-173)
(on page 7-194)
(on page 7-219)
(on page 7-232)