About this Manual
xii
•
,
describes the processes
you must follow to program the subsystems on the KUSB-3100
module using DT-Open Layers-compliant software.
•
provides information that you can
use to resolve problems with the module and the device driver,
should they occur.
•
,
describes how to calibrate the analog
I/O circuitry of the KUSB-3100 module.
•
,
lists the specifications of the
module.
•
shows the screw
terminal assignments for the module.
•
,
“Reading from or Writing to the Digital Registers,”
describes register-level functions you can use to program the
digital I/O lines of the module.
• An index completes this manual.
Conventions Used in this Manual
The following conventions are used in this manual:
• Notes provide useful information or information that requires
special emphasis, cautions provide information to help you avoid
losing data or damaging your equipment, and warnings provide
information to help you avoid catastrophic damage to yourself or
your equipment.
• Items that you select or type are shown in
bold
.
Содержание KUSB-3100
