2-4
2.4
Card installation and removal
This paragraph explains how to install and remove the Model
7038 card assembly from the Model 7001/7002 mainframe.
WARNING
Installation or removal of the Model
7038 should be performed only by qual-
ified service personnel. Failure to recog-
nize and observe standard safety
precautions could result in personal in-
jury or death.
NOTE
To prevent performance degradation
caused by contamination, handle the card
only by the edges and covers.
2.4.1 Card installation
After connecting the input/output cables, perform the fol-
lowing steps, and refer to Figure 2-4 or Figure 2-5 to install
the card assembly in the Model 7001 or 7002 mainframe.
WARNING
Turn off power to all instrumentation
(including the Model 7001/7002), and
disconnect all line cords. Make sure all
power is removed and any stored energy
in external circuitry is discharged.
1. Open the ejector arms at the back edge of the card.
2. Slide the card edges into the guide rails inside the main-
frame.
3. Carefully push the card all the way forward until the
ejector arms engage the mounting cups.
4. Push in on the card edge and ejector arms until the card
is properly seated.
5. Make sure the ejector arms are properly latched.
Figure 2-4
Card installation in Model 7001
Figure 2-5
Card installation in Model 7002
Unlock card
Lock card
Ejector Arms (2)
Ejector Arms
(locked position)
CARD
1
CARD
2
CARD
3
CARD
4
INTERCONNECTION, INSTALLATION AND REMOVAL OF CARDS BY QUALIFIED SERVICE PERSONNEL ONLY.
WARNING:
NO INTERNAL OPERATOR SERVICEABLE PARTS, SERVICE BY QUALIFIED PERSONNEL ONLY.
WARNING:
Содержание 7038
