![background image](http://html2.mh-extra.com/html/keithley/4200-scs/4200-scs_startup-manual_3979314007.webp)
Startup Guide
7
Step 7
Run “vds-id” test
A. In the Project Navigator (see
Figure 5
), make sure the “vds-id” test is highlighted and the checkbox is
checked.
B. On the toolbar, click the green
Run Test
button to run the test one time:
While the test is running, the
Run Test
button turns gray and the
Abort Test
button turns red. Also the
MEASURING indicator (located on lower right-hand corner of the front panel) will be on while the test is
running. When the test if finished, the
Run Test
button turns green.
Troubleshooting hints:
• A selected test will not run if the
Run Test
button is not green. Here are a few reasons why the
Run Test
button will not be green:
-
A test is still running.
-
The checkbox for the test is not checked (see
Figure 5
).
-
Changes to the test setup were not saved (see Step 6B).
• If a selected test still will not run, click the
Status
tab for the test. This tab provides status information
for the test.
Click
Run Test
to start test.