![background image](http://html2.mh-extra.com/html/keithley/2657a/2657a_reference-manual_4007750422.webp)
Model 2657A High Power System SourceMeter® Instrument Reference Manual
Section 7: TSP command reference
2657A-901-01 Rev. B/December 2012
7-109
lan.autoconnect
This attribute is used to enable or disable link monitoring.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
LAN restore defaults
Nonvolatile memory 1 (lan.ENABLE)
Usage
state
= lan.autoconnect
lan.autoconnect =
state
state
LAN link monitoring state:
1
or
lan.ENABLE:
Enables automatic link reconnection and monitoring
0
or
lan.DISABLE:
Disables automatic link reconnection and monitoring
Details
This attribute sets the LAN link monitoring and automatic connection state.
When this is set to
lan.ENABLE
, all connections are closed if the link to the LAN is lost for more than the time
specified by
lan.linktimeout
.
Set this attribute to
lan.ENABLE
to automatically reset the LAN connection after the LAN link is established.
Also see
(on page 7-116)
lan.config.dns.address[N]
Configures DNS server IP addresses.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
LAN restore defaults
Nonvolatile memory "0.0.0.0"
Usage
dnsAddress
= lan.config.dns.address[
N
]
lan.config.dns.address[
N
] =
dnsAddress
dnsAddress
DNS server IP address
N
Entry index (1 or 2)
Details
This attribute is an array of DNS (domain name system) server addresses. These addresses take priority for
DNS lookups and are consulted before any server addresses that are obtained using DHCP. This allows local
DNS servers to be specified that take priority over DHCP-configured global DNS servers.
You can specify up to two addresses. The address specified by 1 is consulted first for DNS lookups.
dnsAddress
must be a string specifying the DNS server’s IP address in dotted decimal notation.
Unused entries are returned as
"0.0.0.0"
when read. To disable an entry, set its value to
"0.0.0.0"
or the
empty string
""
.
Although only two address may be manually specified here, the instrument will use up to three DNS server
addresses. If two are specified here, only one that is given by a DHCP server is used. If no entries are specified
here, up to three addresses that are given by a DHCP server are used.
Содержание 2657A
Страница 3: ......