Model 2520 User’s Manual
Getting Started
1-7
Operation keys:
EDIT
Enter EDIT mode.
MATH
Enable math function.
LOCAL
Cancel remote operation.
RECALL
Display stored readings and timestamp.
FILTER
Control digital filter.
DIG OUT
Set Digital I/O port output value.
TRIG
Trigger a measurement from the front panel.
SWEEP
Start configured sweep.
PW
Set laser diode current source pulse width.
DELAY
Set laser diode current source pulse delay period.
COMM
Select remote interface, set GPIB and RS-232 operating parameters.
SETUP
Save/recall default or user instrument setup configurations.
CONFIG
Press CONFIG and then appropriate key to configure function or operation.
MENU
Access and configure Main Menu selections. When entering numeric data, use to
clear reading to minimum absolute value.
EXIT
Cancels selection. Use to back out of menu structures.
ENTER
Accepts selection.
Annunciators:
EDIT
Instrument in edit mode.
ERR
Questionable reading, invalid cal step.
MATH
Math function enabled.
REM
Instrument in GPIB remote mode.
TALK
Instrument addressed to talk over GPIB.
LSTN
Instrument addressed to listen over GPIB.
SRQ
Service request over GPIB.
FILT
Digital filter enabled.
ARM
Source-measure operations being performed.
TRIG
External trigger source selected.
Output control:
ON/OFF OUTPUT Turns the source outputs on or off.
Handle:
Pull out and rotate to desired position.
Rear panel summary
The rear panel of the Model 2520 mainframe is shown in
.
Содержание 2520
