12
AIR300 LEG PRESS
|
OPERATION MANUAL
PROPER OPERATION CHECK
Check equipment condition and function before every workout:
Immediately replace damaged, worn, or broken parts. Do not use the Air300 Leg Press until all repairs have been completed
and tested by a Keiser-certified technician.
* “Lo-bA” = Batteries are low, replace immediately. If batteries are dead (depleted), the Power Display remains blank (see
Battery Replacement procedure, page 17).
A.
Stability
— equipment is level to a solid, flat surface.
B.
Upholstery
— no excessive wear, free of rips or tears.
C.
Thumb Buttons and Display
— press Thumb Buttons
to check for proper “+ / -” operation; power on the
Display*.
D.
Seat
— Seat Lever allows the Seat to slide freely; locks
the Seat into position.
E.
Foot Pads
— No excessive wear on the rubber surface.
F.
Lock Bar
— Slides freely and fully locks into position.
G.
Movable Stops
— Set properly under the red dots; no
excessive wear on rubber tips.
H.
Exercise Arms
— Move freely; no loose parts in the
linkage.
I.
Air Leaks
— No air leaks audible in the system.
J.
Stop/Release Bar
— Move freely and properly sets the
Movable Stops into the stop and release positions.
Figure 8. Proper Operation Check Illustration
C
D
E
F
G
I
J
B
A
H
