MaltZilla Instruction Manual
Page
7
of
11
www.KegLand.com.au
Last Updated 28/05/2021 3:36 PM
Operating Procedure
1.
Attach MaltZilla with hopper firmly to base board or bench
2.
Set the desired gap size
3.
Plug power supply into standard 10A AC wall outlet or alligator clips onto battery.
4.
Turn the power switch on the wall outlet to “On”
5.
Place a bucket under the MaltZilla to collect milled grain
6.
Load grain into the Hopper
Note:
Ensure the MaltZilla is on and the driven roller is spinning prior to loading grain into the
hopper.
MaltZilla Maintenance
Cleaning
The MaltZilla should be cleaned after each operation by using compressed air to blow debris out of
the mill. Any debris surrounding the MaltZilla can be collected using a vacuum. The resistance of the
non-driven roller should be checked by rotating the roller with your fingernail, if it does not rotate
with minimal resistance or you are finding that the MaltZilla is not feeding grain from the hopper
during operation then the MaltZilla needs to be disassembled and the rollers and housing cleaned
thoroughly. The MaltZilla can be disassembled and cleaned quickly and easily via the following:
1.
Undo the 8 hex bolts on the side of the MaltZilla using an xmm allen key and remove the
housing.
2.
Remove the detended gap adjustment knobs from the non-driven roller and remove the
non-driven roller from the housing.