MaltZilla Instruction Manual
Page
2
of
11
www.KegLand.com.au
Last Updated 28/05/2021 3:36 PM
The MaltZilla has an integrated high torque 24V motor which is powerful enough to chew
through malt or hard grains such as wheat or malted corn with ease, with the rollers staying
as sharp as day one even after extended use.
To get started you will need to choose a power supply. There are a number of suggested
power supply options providing you with flexibility in how you choose to power your mill,
including:
-
24V DC (20Amp) Power Supply with Anderson Plug
–
un-wired (
-
24V DC Power Supply
–
For Manual Cannular and MaltZilla (
-
24V DC Power Supply
–
For Semi-Auto/Manual Cannular and MaltZilla (
The MaltZilla can also be powered by a car battery or deep cycle battery using a power cord
with a 40Amp rated Anderson Plug x Alligator Clips (
If you are using an unwired power supply or a battery as your power source it is a good idea to check
the polarity of the DC voltage which should be positive. This can be checked using a multimeter.
Negative polarity can result in damage to the motor after extended use and/or grain not
being efficiently drawn into the mill.
Hopper Installation and Mounting Maltzilla to Base Board
Remove the two, bottom central 5mm hex bolts and insert the bottom hopper feeder pipe and then
secure with the 5mm hex bolts as shown below: