5. CLEANING AND WASHING FIRST INSTALLATION.
Wash machine thoroughly to eliminate any residue and any dust on its surface. Take care of the engine, cord and
plug. If the electrical component are wet, wait till they are dry before to start.
6. WIRING CONNECTION
To start the machine, proceed with the electrical connection which must be carried out by a qualified technician.
Avoid wetting the plug and socket.
Check the label on the motor and the adequacy with user’s electrical system.
The safety of this crusher is valid only if there i san user’s electrical system complies with the law
regulations in force and that its maximum power absorption is taken into.
If it is necessary to use extension or multi-socket , use only material conformed to the law regulation in force and
respect the limit of maximum power absorption. We suggest to use a cord wide 1,5 mm for extension till 20mt,
and wide 2,5 for longer distance.
7. START AND STOP
Important: before starting the machine, ensure that there is nothing that prevents the mechanical
parts from moving freely and, above all, that nobody is close to the moving parts of the machine.
More specifically, hands, arms and other body parts must be kept away from the inside of the box.
Ensure that the engine voltage corresponds to the voltage of the mains.
Avoid moving the machine while it is in operation. Machine start-up must not be carried out barefoot, with bare
or soaking wet hands. Check that both plug and socket are in working order. We recommend that rubber gloves,
boots and an apron be worn by the user while using the machine.
Check the correct installation of the safety protection
Check the emergency stop of the motor work good.
If there are no problem during this control, proceed as following:
Press start bottom, and the machine will start to work
Load the grape or the fruit inside the hopper
The grape will start to be pressed by the roller and destemmer by the shaft
To stop the machine press the safety stop
To start again , open the safety switch and press again the green bottom
If it is necessary to repair the machine (obstruction or foreign body), make like this:
stop and disconnect the motor from the main;
Remove item from the inside of the machine by using a suitable tool and if necessary open the machine
close the machine, and check to have all the protection install
Do not carry out introduction of body part or instruments, or maintenance work while the
machine is in operation.
8. CLEANING AND MAINTENANCE
After using the machine and in any case at the end of each working day, unplug the machine from the main and
wash thoroughly to eliminate any residue .