Kegel Toner, Инструкция по эксплуатации

Страница: 15 / 32

14
9.2. OPERATING
INSTRUCTIONS
ON/OFF
To turn the unit on, press the
ON button and hold for 3 to 5
seconds until the display
shows.
To turn the
unit off, press ▼
button to remove keypad lock and press
the
OFF button and hold for 3 to 5
seconds until the display stops.
At first use, or after changing batteries,
the display shows that the unit is
automatically set in program
TRAIN at
zero strength.
When switched on the unit will
automatically start in the program which
was being used when it was last
switched off.
The strength returns to about 50% of
the level that was being used when the
unit was switched off. This simplifies
start up dramatically.
During start up to stop the increase in
strength at any time, press any key
once.
The unit will turn off automatically:
•
When the Timer reaches zero,
•
If it is left at zero strength for more
than 5 minutes.
Note: Always check unit is
OFF before applying or
removing Kegel Trainer .
The backlight will turn off 10 seconds
after the last button press.
STRENGTH CONTROLS
The buttons marked
▲ and ▼
are the strength controls.
To increase strength, press
and hold down the button
▲
until required strength is
achieved.
To decrease the strength, press and
release the button
▼.
To increase strength in steps of 1 mA,
press and release the button
▲.
The unit will remain in the WORK part
of the cycle for 5 seconds while
intensity is being adjusted.
The strength levels are shown on the
LCD.
The strength control buttons will not
operate until the unit is properly
connected to you (Kegel Trainer
inserted correctly). Kegel Toner
detects
a disconnection and
automatically returns the strength to
zero.
The unit has 99 levels of strength. If you
hold down the button
▲ for 3 to 5
seconds, the strength will start scrolling.
You may feel nothing over the first few
presses. Continue pressing until the
sensation is strong but comfortable.
Further increases during use may be
necessary if your body becomes used
to the sensation.
The yellow LED on the output socket
indicates that there is an active output.
The display will remain on for 5 seconds
after the plug is removed.
PROGRAM CONTROL
The button marked P is the
program control. The Kegel
ON
OFF
▲
▼
P