KEF BSH 20-75CGC, Инструкция по эксплуатации

Страница: 12 / 29

11
larger than Ø25 and the support plate is used for the smaller tube dimensions smaller
than Ø25.
3.2 Setting the fork
The fork height is set depending on the tube dimension Ø(inch). Loosen the lever and
move the fork to the tube dimension, which is to be processed. The scale on the left is
used with the help of the support Teflon. The scale to the right is used with the help of
the support roller as seen below.
Diagram 3.2: The fork can slide up and down on the scales.
3.3 Putting the article in the machine
Place the article in the machine. Pull the propulsion jig to the open position (see
diagram 2.4). Place the tube in the machine and adjust the pipe clamps so that they
support it. Close the machine.
Remember for safety
It is important to emphasize that when the tube is running, there is a chance that it
can jump out of position. See diagram 3.3. For this reason, remember that the centre
of the tube should never come past the centre of the support roller.