KEEWAY ATV250, Руководство по обслуживанию и ремонту

Страница: 10 / 97

6
Electricals safety
1.
A loose wire harness can be a safety
hazard.After clamping,check each wire to be
sure it is secure.
2.
Don’t curve clamps towards welds.
3.
Secure wire bands to the frame at the
designated locations.Tighten the wire bands
(strap) so that the insulated surfaces can
contact the wire wirenesses.
4.
Route wire harnesses and cables to avoid
frame ends or sharp edges.
5.
Route wire harnesses to avoid the projected
ends of bolts and screws.
6.
Keep wire harnesses and cables away from the
hot parts or area where they might be pinched
between the moving parts.
7.
Wire harnesses routed along the handlebars
should not be pulled tight or have excessive
slack or be pinched or interfere with adjacent
or surrounding parts in all steering positions.
8.
Check that the wire harnesses are not twisted
or kinked.
9.
Ascertain that there is a damage of connector
cover,and
if its terminal is opened
excessively,before connection.
10.
Protect wires and harnesses with tape or a tube
if they contact a sharp edge or corner.
11.
After repairing wire harnesses,wrap with
protective tape or replace them.
12. Don’t bend or twist the control
cables.Damaged control cables will not
operate smoothly and may stick or bind .