KEEWAY ARN125, Руководство по обслуживанию и ремонту

Страница: 46 / 85

46
C a r b u r e t o r r e m o v a l a n d i n s t a l l a t i o n
Removal
： ： ： ：
1. Remove rear seat of motorcycle;
2. Postion fuel switch on “ OFF” position
；
3. Pull out inlet oil paste tube with jaw
；
4. loose clamp ring between carburetor and air cleaner
；
5. Pull out the stopper at the tail of discharging oil paste tube, spill fule in floater chamber into another
box.
；
6. Loose the screw for jointing carburetor and engine and take out carburetor
；
7. Pull out high coil cap;
8. Pull out electric condensing valve joint;
9. Loose the screw for jointing carburetor and engine and remove carburetor;
10. Loose throttle cable.
Installation
： ： ： ：
The installation sequence is essentially the reverse of removal.
Notice
： ： ： ：
1
、
Confirm electric condensing valve wire is connected correctly;
2
、
Confirm carburetor is intalled correctly and no oil leaking out.
CARBURETOR ASSY.
STEPS FOR REMOVAL
： ： ： ：
1
、
Remove 4 screws, take out stopper spring and stopper assy;
2
、
Unscrew oil needle compaction cap, take out oil needle and oil needle spring;
3
、
Unscrew misture ratio adjusting screw, spring, gasket and seal ring;
4
、
Unscrew idle adjusting screw and screw
；
5
、
Remove electric condensing valve assy.
；
6
、
Remove choke valve assy.
；
7
、
Remvoe the 4 screws on under cover;
8
、
Remove floater pin, floater and needle valve in turn
；
9
、
Remove main jet, foam tube and main nozzle in turn
；
10
、
Unscrew idle jet
；
11
、
clean various parts with gasoline, and then blow them with high pressure pneumatic gun.
Notice
： ： ： ：
1
、
In the process of removing other accessories in floater chamber, first of all remove floater and needle valve
to ensure floater is not damaged
；
2
、
To preserve main nozzle, remove it from one side of stopper hole.