KeepGuard KG760EB, Инструкция по эксплуатации

Страница: 31 / 37

31
spaces 1-4 with no ″gaps″
.
KeepGuard recommends using 8 Energizer®
Lithium AA batteries in all KeepGuard Cams.
2. Make sure that the batteries are installed correctly, observing proper
polarity. Always place the negative (lat) end of each battery in contact with the
spring side of its slot inside the camera.
3. After moving the switch from ″Off″ to ″Setup″ or ″On″, make sure that
the switch is correctly in position to ensure the proper mode (avoid positions
“between” two modes).
4. Do not move the switch directly from ″On″ to ″Setup″ - always move the
switch all the way down to ″Off″ first, then back up to ″Setup”.
Still Photo and/or Video Quality Problems
1. Night photos or videos appear too dark
a. Check the battery indicator icon to see if battery power is full. The flash will
stop operating near the end of the battery life.
b. You will get the best results when the subject is within the ideal flash range,
no farther than 45′ (14m) from the camera. Subjects may appear too dark at
greater distances.
c. Please note that when the Capture Number parameter is set higher than “1
Photo″, or with very short Interval settings, some images may appear darker
than others due to the quick response and rapid retriggering of the camera,
allowing less time for the flash to fully recharge before firing again.