3.4
3.4
Operation
Using the Bevel Cutter
A
1.
When cutting Flexo Plate always use a cutting mat to cut onto and ensure the blade depth is set
to a minimum to cut through the material thickness. A cutting mat is supplied but experimentation
using other materials such as good quality card can give good results.
2.
It is important that the silicon grip tape (A) on the underside of the cutter bar is kept clean to hold
the flexo in place.
If it becomes dirty through use clean it with a cloth moistened with diluted detergent.
Helpful hints:
•
To eliminate entry and exit burrs, push the blade into the flexo, through the base,
to start your cut.
•
If you cut with the base side up, place the foam protector sheet (used for shipping between each
flexo plate), on the base board, to protect the emulsion side from scratching.
•
To obtain smooth clean edges and avoid fracturing (especially on thicker flexo plates) make
multiple passes and frequent blade changes.