Keeler Pulsair Desktop, Инструкция по эксплуатации

Страница: 19 / 32

Next Home
Back
19
11. Display examples
S T A R T I N G . . . . . . . .
R U N S E L F T E S T ?
S E L F T E S T R U N N I N G
R : 1 6 : 1 6 1 6 1 6 1 6
S T A R T I N G
K E E L E R P U L S A I R
O K
The unit will display ‘STANDBY’ when the power is on.
The unit will display ‘STARTING’ while the system initialises.
Individual readings, along with the running average (on the left
hand side of the display) of measurements taken so far will be
displayed. The decimal point in the running average is selectable
by the user. i.e. ’16.5’: if the xx.x setting is selected in the SET
IOP Format or 16 is displayed if xx is selected through the menu
system (refer to section 14). Outlying or spurious readings will
automatically be excluded from the calculation.
When a pressure (IOP) of less than 5mmHg is detected, the unit
will display ‘<5 READ AGAIN’.
When a pressure (IOP) of greater than 25mmHg is detected, the
unit will display >25. When a pressure (IOP) of greater than
50mmHg is detected, the unit will display >50. In each case, the
puff intensity will automatically be increased from the soft puff
to the normal puff level for subsequent measurements. In these
cases the user does not need to reset the instrument.
A self test program can be run for diagnostic purpose by
selecting the Menu Option. The display will show run self test.
By pressing the Clear/Demo button self test is entered and the
display will show self test running, and this will run for 45
seconds. At the end of the test the resulting data is
sent to the printer and the display
is cleared.