For indoor use only (protect from moisture)
To prevent condensation from forming, allow instrument to come to room
temperature before use.
When connecting instrument heads to handles check that voltage of the bulb
in the instrument corresponds with the voltage of the handle.
Ensure that the control is in the off position when the examination has been
completed.
When replacing Lithium cell, turn handle off and insert new cell. Replace
bottom cap, and place handle into charging well.
Environmental
Dispose of battery in line with local regulations on recycling of batteries.
Tape over battery contacts to avoid short circuiting during disposal.
Li-ion batteries contain no toxic heavy metals, such as mercury, cadmium or
lead.
Keeler Handle & Bulb Identification
Keeler handles & bulbs are colour coded to allow you to distinguish between
a dry cell battery handle (2.8V) and a lithium handle (3.6v). The handles
are colour coded as follows:
Blue Base = 2.8v for dry cell batteries
Red Base = 3.6v for Lithium batteries
Please ensure when replacing bulbs that the voltage corresponds to the
handle voltage.
Inserting/Replacing Batteries
Unscrew battery cap, insert batteries and replace battery cap as shown in
Fig 1.
2xAA (LR6-AM3-MN 1500)
LINER SLEEVE
BLUE
RED
EP39-18918
Fig. 1
Always ensure that the handle rheostat is turned off before fitting an
instrument head or changing a bulb.
If a short curcuit occurs, reactivate the battery by placing the handle in the
charger until the LED flashes.
This is a built in protection device to protect the battery from damage.
