HFL010
Issue 01
PLEASE BE ADVISED:
Before assembling the Hands Free Ladder for the first time, it is highly
recommended that Installers familiarise themselves with the component parts and carry out a test
assembly and disassembly in a safe area away from the point of final installation. All component parts
detailed in the operating instructions must be used in the assembly of the system. Should a piece be
missing or appear defective do not continue to assemble and contact Easi-Dec Immediately.
Step 1 Step 2
FIG 1. Roller wheels
Roll the Ladder up the wall into position with the roller wheels.FIG 1.
Always erect using the 4:1 rule.
Level the Hands Free Ladder adjusting the feet either up or down.
Make sure the Pin and ‘R’ Clips are both replaced.
Step 3 Step 4
Lift the upper Ladder to the desired location and re-seat onto the
rungs with the attached hooks. Make sure the Ladder is positioned
correctly using the 4:1 rule.
Release the rear leg by removing the Pin and ‘R’ Clips and re- fit into
the second hole located on the angle bracket.
Step 5 Step 6
Release the foot allowing it to drop onto the ground and refit the
Pin and ‘R’ clip to the nearest hole.
Always tie the Hands Free Ladder to the building with the Tie-off kit
supplied.