Kedacom NVR2860E, Руководство по установке

Страница: 18 / 24

5. Connect the green-yellow wire to the ground bolt of the NVR2860E.
6. Connect the G-LAN 1 network port to the Internet.
Depending on onsite conditions, connect the G-LAN 2 network port to the Internet.
You are advised to use RJ-45 network cables.
7. Connect the NVR2860E to a display that provides an HDMI and/or VGA port.
8. Connect the power cable to a power outlet.
9. Turn on the power switch on the rear panel.
【 Note 】
To switch off the NVR2860E, click the related button on the OSD of the NVR2860E or
on the NVR Station. To switch on the NVR2860E, press the power button on its front
panel.
You can connect the NVR2860E to other devices (for example, a speaker). However,
this document does not provide the corresponding details.
5 Power-on Self-Test
After the system is started up, check whether the the status of the LAN and PWR indicators on
the front panel is normal.
If yes, the system is operating properly.
If not, contact the system administrator or the local authorized Kedacom agent
.
To prevent the risk of lightning, you are advised to ensure the following:
The NVR2860E is well grounded.
The green-yellow wire is properly connected to the ground bolt of the NVR2860E.
The connection between the natural points of alternating current (AC) outlets and
the earth ground is normal.
Based on onsite conditions, install lightning arrestors.
6 Product Care
6.1 Lightning Protection
6.2 Lithium Battery Replacement
The system clock uses the CR2032 button cell lithium battery. When the battery loses its
charge, the system may malfunciton. You must call the local authorized Kedacom agent to
replace the battery. Do not attempt to replace the battery yourself.
7