9 130903
V1.1
●Use only accessories that are recommended by the manufacturer for your product. Accessories are suitable for
the tool, but may become hazardous when used on another product.
●Dry your hands before turning the tool ON or OFF.
● Protect against excessive heat. The product should be kept away from heat sources, such as radiators
、
heat
registers
、
stoves or other products (including amplifiers) that produce heat. Don’t use the tool near moving
machinery or areas where the temperature is exceed 45
.
℃
● Please cover the camera protection while not in use.
● Store the product in ventilated and dry places.
Maintenance Instructions
●Product service must be performed only by qualified personnel. Performed by untrained personnel could result
in injury.
●When servicing the product, only use identical replacement parts. Use of authorized parts or failure to follow
maintenance instructions may create a risk of electrical shock or injury.
●Don’t attempt to disassemble the product other than the needs specified on this manual.
●Provide proper cleaning: don’t use acetone to clean the product. Gently clean the LCD with a soft dry cloth.
●Upon completion of any service or repair, please ask the service technician to check if the tool is in proper
condition.
。
●Stop using the unit if it starts smoking or emitting noxious fumes.
●Please ask qualified person under the following conditions:
a
、
If liquid has been spilled or objects have fallen into product.
b
、
If product doesn’t operate normally even if you have followed the operation instructions.
c
、
If the product has been dropped or damaged in any way.
d
、
When the product exhibits a distinct change in performance.
Trouble Shootings
Problems
Causes
Solutions
Can’t charge.
Adapter didn’t connect well
with the product.
Please check and try again.
The connect or or cable is
broken.
Replace and try again.
Dead battery
Ask a technician to replace the
battery.
The screen is on but
without image or shows
“No Signal”
1
、
Different channel set
between the grip and screen.
Set the same channel.
2
、
The probe is loosed.
Check and connect again.
