4.Please try to avoid using the tool on wet plate and wall.
5.Sometimes, the scanner cannot detect the slate or mixed plate correctly because the density of the
materials change a lot.
6.When tacking, cutting or drilling on the wall, ceiling or floor, please take care to the wires and
pipes on the back of them.
7.The covered wires, useless wires, telephone lines, CATV wires and circuitries without electricity
could not be detected as live wires.
8.When the thickness of detected wall is over 3/4 inches or the joists are close to each other, joist
detection is not suitable, generally, the space between joists is 16 or 24 inches, and the width of
the joist is 1-1/2 inches.
9.The detection is not suitable for metal wall or the wall with high density materials of metal.
10.When constructing beside the AC live wires, the power supply should be switched off.
11. If the tool cannot calibrate or detect normally, possible reasons are as follows:
a
）
When the battery is low, the “
” symbol will blink continuously on the screen after
calibration. Replace with new battery according to instructions.
b
）
In order to make sure that the scanner is on the best state during detection, hold the tail of the
tool when operation and keep the other hand at least 6 inches away from the tool during
detection.
●
Laser marking function
Press the K button to the "LASER" location, the tool will enter laser marking function. The
laser diode is powered and emit laser line.
1. Tool fixation
When using the tool on the dry wall or wooden wall, you can locate the tool by push pins
fixation function:
1) Locate the tool on the desired place.
2) Push inward and keep pressing the protect buckle on the
side of the push button , making the buckle claw break away
from the joint surface.
3) Press the push pin button N emphatically. Forelock the
push pin into the wall and make sure the fixation is firm.
Notice:
a. Please don’t press the push pin without breaking protect buckle away from the joint surface to
avoid damage to the tool.
b. When the push pin is not needed, please pull the pin back to make sure the push pin protect
buckle has been retracted to original place to avoid damage
13
