●
Press MODE key to clear the current displayed data, then can begin the second time measurement and
computation (Follow step 1 to 3 under the volume section);
●
After getting the calculated volume of second time, press +/= key to enter the addition mode. A “+”
icon would appear on LCD;
●
Press RM key to recall the first calculated volume for the addition. The “M+” icon will disappear and
the stored memory will be automatically cleared;
●
Press +/= key, the sum of both volumes is shown on the lower portion of the screen;
●
Repeat the steps above to keep adding the measured volume.
8
、
Temperature display
Press and hold MODE key and at the same time press the RM key, the environment temperature will
appear on the lower portion of screen (the unit is
℃
if the distance unit is M, while the unit is
℉
if the
distance unit is ft/in), and press the READ key again to return the measuring state.
●
Stud detect
Press the “k” button to the "DETECTOR" location, the tool will enter detection state and wait to detect.
1
、
Calibration
The tool should be calibrated on the surface of the detected object before detecting or after
function “D” switch’s diversion.
10
