A2xx
Operation and handling
Operating instructions V1.01
29
© KEBA
Fig. 5-9: Installing the measuring aid
1) Position the two upper guiding lugs of the measuring aid on the upper
recesses of the device (
1
).
2) Fold the lower part of the device in the direction of the measuring aid so
that the two lower bending lugs of the measuring aid rest within the
lower recesses of the device (
2
).
Information
If installed correctly, the measuring aid rests on the device completely.
The measuring aid has now been installed on the device, and the manual
measurement can be executed.
Carrying out the measurement
For the manual measurement, proceed as follows:
1) Attach the measuring aid to the device.
2) Switch the device on by pressing the operating button.
3) Navigate to the
Manual
menu item by pressing and holding the operating
button.
4) Place the device close to the workpiece so that the measuring aid
touches the bending edge.
5) Start the measurement (switch on the laser) by pressing the operating
button once.
6) Position the device so that the laser beam can hit both legs of the work-
piece at an angle of 90° without being obstructed.
7) Hold the device still until the measurement is complete and the laser
switches off automatically.
The measured result can be read off the display after the measurement has
ended. The laser is automatically switched off after the measurement.
Содержание KeMes A2 Series
