30
04/12/2017
rev.02
Italia
Use and maintenance manual
6 Technical data
6.1 Technical features
Max. dimensions (mm) and weight (Kg/m
2
)
Italia
Width
5000
Height
3600
Projection (awning open)
1800
Approx. weight (kg)
50
Roller tube (Ø)
70
Safety performance per EN13561
Wind resistance class
2
Nominal test pressure p(N/m
2
) α=1
70
Wind speed (Km/h)
38
Total transmittance of solar energy g
tot
see attached label
MOTOR
Type
see manual for installed motor
Specifications
CE marking, approved for sun awnings
For the specifications of the optional accessories, see Cap.9 “Optional”, pag.31 and the corresponding
instructions.
· The resistance to pooling water is tested with an inclination of 25%; retract the awning during rain if
the angle is less than this.
· The maximum load permitted for non-retractable parts is 800 Pa.
· The resistance to pooling water is tested with an inclination of 25%; retract the awning during rain if
the angle is less than this.
· The maximum load permitted for non-retractable parts is 800 Pa.
6.2 Technical label
The “technical label”, which is on the inside cover of this manual, specifies the year in which the CE marking, the
manufacturer’s data and the specific product data were applied.
7 Transport and Installation
7.1 Transport
Transport and shipping shall be borne by the reseller and/or the manufacturer, who shall transport the product
using adequate packages to protect it up until its delivery to the final customer.
Any damage to the product sustained during removal and subsequent handling and/or transport,
performed after the initial installation, is not covered by warranty.
The packaging material must be disposed off and/or recycled according to the applicable local legislation.
7.2 Installation
Assembly of the components, installation and first start of the product must only be performed by
specialised and qualified technicians, and is the responsibility of the reseller and/or manufacturer.
All the instructions and the main safety standards to perform these operations are described in the “Assembly
Manual” and the “Installer Manual”.
