HD V
iew4
6
Introduction
DISTRIBUTION AMPLIFIERS
Tech Support: Toll Free USA/Canada 888-258-2028 [email protected]
Customer Support: 718-796-7178 Ext. 23 [email protected]
STEP A2:
Set the internal DIP switches to match the Configuration Mode
you need for your application.
• Remove the front panel using a screwdriver, and find the six 8-bit DIP
Switches. Be sure to configure the six 8-bit DIP Switches as shown in the table
below for either the ADA4 or PCMD4 Mode:
STEP B:
Connect your KD-ADA4 HD View4 Distribution Amplifier to your
Input and Output sources.
NOTE: Do not attempt to connect power to the unit during the
cable hook-up.
STEP B1:
Based on your configuration selection, be sure to set the DIP
Switches as described in STEPS A. Use color-coded RCA cables to con-
nect the Inputs and Outputs to the back of the KD-ADA4 HD View4 unit.
Output runs should not exceed 1000 feet. Each run of YPrPb cable MUST
be of equal length per Output Group.
STEP B2:
For the ADA4 Mode where less than four video outputs are
distributed, be sure to use the 75 Ohm terminator (supplied) to terminate
either Y, Pr, or Pb of the first unused Output Group. For example, if dis-
tributing with only Output Groups 1 and 2, then place the terminator on Y,
Pr, or Pb of Output Group 3. You should use the Output Groups in
sequential order.
STEP C:
Apply power to the unit:
• Use ONLY the external wall-plug power supply provided with your unit, 110-
240V AC, 50-60 Hz, 0.9 Amps
• Connect the 5-pin DIN external power supply connector to your unit, and plug
the power supply into a power outle
SW1
SW2
SW3
SW4
SW5
SW8
BIT ADA4 PCMD4 ADA4 PCMD4 ADA4 PCMD4 ADA4 PCMD4 ADA4 PCMD4 ADA4 PCMD4
1
ON
OFF
ON
OFF
OFF
ON
OFF
ON
OFF
ON
ON
OFF
2
OFF
ON
OFF
ON
ON
OFF
ON
OFF
ON
OFF
OFF
ON
3
OFF
OFF
OFF
ON
ON
OFF
OFF
ON
OFF
ON
OFF
ON
4
OFF
OFF
ON
OFF
OFF
ON
ON
OFF
ON
OFF
ON
OFF
5
ON
OFF
ON
OFF
ON
OFF
OFF
ON
OFF
ON
ON
OFF
6
OFF
ON
OFF
ON
OFF
ON
ON
OFF
OFF
OFF
OFF
ON
7
OFF
ON
ON
OFF
OFF
ON
OFF
ON
ON
OFF
OFF
ON
8
ON
OFF
OFF
ON
ON
OFF
OFF
OFF
OFF
ON
OFF
ON
