■
■
●
●
●
①
②
③
●
●
●
●
How to use
Taking care of the dehumidifier
Turn off the unit (press the POWER Off / On button),
Use water to rinse these parts 2 or 3 times.
Use a mild kitchen cleanser for
stubborn stains.
Be sure to put the tank lid, tank cap,
and buckles back on the tank.
Failure to do so may cause water to spill.
Do not remove the float.
If the float is off, the unit will not operate.
If the float is not attached properly,
water may leak.
If the float comes off
Place the float along two axes in the tank
lid (reverse side) and make sure that it is put
in correct direction. (See the figure above.)
Depending on where you use the
dehumidifier, the internal of the tank may
get especially dirty due to the dirt and
dust in the air.
Be sure to push the tank gently all the
way into the unit. (If not, the unit will not
operate.)
You can clean the slime without
removing the float.
Tank, Tank lid, Tank cap, Buckles
Float
Disassembling the tank set
Assembling the tank set
Remove the left and right side buckles.
Remove the tank lid.
Remove the tank cap.
Pull it up and off.
Perform the disassembly
procedure in reverse.
Remove the dirt around the two axes.
(Keeping these clean will prevent the
float from malfunctioning.)
Tank cap
Tank lid
Tank
Buckle
Buckle
Tank lid (reverse side)
Axes
Tank
Tank lid
Float
Buckle
Pull out the power plug,
Drain the water.
(
Page 16)
Cleaning the tank set (once a month)
Float
17
YT60ZH
