KDK FY-3009U1, Инструкция по эксплуатации

Страница: 11 / 40

How to install
10
4.Installation of product
1.Place the product on the mounting plate.
2.Adjust the position of the product.
Align the groove of back panel with both sides of
mounting plate. Fit the holes into the hook from
mounting plate.
3.Fasten the screws. (3 places)
※
The torque is suggested
to be 1.2N·m.
Back panel
Mounting plate
■
Product should be installed by
2 persons.
Otherwise, the product
may fall down and it may
cause injuries.
Groove
5.Installation of sensor
1.Place the sensor with wire on top of door. Fix the sensor with screws.
2.Place the other sensor under the sensor with wire,
the distance between them should
be 8mm below, as shown in figure.
If the magnet part fixed on steel or
iron doors, the distance should
be 5mm below.
3.Connect the sensor and main body
and wrap it with insulation tape.
1.When connection is complete, please do the trial operation.
If it works normally, follow the next step. If sensors still don’t work, adjust the distance to work
normally.
2.After the trial operation, fix the wire with groove or cord clip to make sure the wire is fastened
so that it will not be damaged by door movement.
3.For sliding door, the door with sensor should keep over 10mm from the door at the same side
to protect against the damage.
4.For glass door, stick the sensor with double adhesive tape.
NOTE
Shadow area is
wrapped with
insulation tape.
Conected to
main body
Connected to
sensor
CAUTION
Mounting
plate
The power cord and the
sensor wire should laid
apart,withe a distance
above 150mm.
Power cord
Sensor wire
（
About 2000mm
from bushing to
connector
）
8mm below