FRAMELESS GLASS WALL UNIT
#16522
PAGE 3 OF 10
www.kc-store-fixtures.com
7400 E. 12th Street, Kansas City, MO 64126 • 1-800-862-0899
OPTIONAL
Turn base over so bottom is facing up. Using a rubber mallet,
add glides (J) to each corner of the base. Once glides are in
place, turn base right side up to start with STEP 1.
It is recommended two people assist with the assembly of this unit.
STEP 1
Install bottom door track (M) onto top of base (P).
Look for 2 small drill holes along front edge of base. (Fig. 1a) Note, drill holes are offset on purpose.
Begin by sliding the center section of door track (M) to the right, this will reveal screw hole. Position track so screw hole aligns
with pre-drilled hole in the wood base. (Fig. 1b)
Use wood screw (K) to attach lower track. Do NOT fully tighten screw until BOTH screws are in place.
Once screw is in place on left side, slide center track to the left, to reveal the screw hole on the right end of the track.
Position so screw hole aligns with pre-drilled hole in the wood base and add remaining wood screw. (Fig. 1c)
Once BOTH screws are in place, you may tighten them all the way down.
(Fig. 1c)
(Fig. 1b)
(Fig. 1a)
Left screw
hole
Right screw
hole
J
