17
GB-Gas Wok Ring Table
Amicus- Gas-20190620
FR
M
-P
DE
-0
3-
04
(N
YT
/R
&
D/
20
18
10
08
)
4.5 Gas Supply Connection
1. Before installing and connecting Gas Wok Ring Table to gas supply, carefully control the fixed part of gas
system, which conformed to National Building Regulation.
2. Verify gas pipes sections to guarantee sufficient supply for all gas heated appliances. Install it in similar
condition to avoid excessive pressure drops.
3. The pipes must be made of steel (with junctions made using white cast iron, or galvanized steel fittings, or
autogenously welded joints) or copper pipes (with mechanical joints and couplings without seals or mastics
or brazed joints).
4. Control the gas bottle (if any) placed correctly and protected in dry area.
5. Check whether the gas pipes can easily inspected. If the pipes installed in floor and wall, make sure that this
work done according to professional standard with reference points that make it possible to find the pipes.
6. Before installing Gas Wok Ring Table, make sure that it is set for the gas and pressure (see Technical Data
Plates). Consult the paragraph “Gas Conversion”.
7. Connect Gas Wok Ring Table to gas supply using solid fittings or flexible steel pipes with suitable sections
related to nominal power and length.
8. Check whether the flexible pipes does not pass or near hot surfaces, put under stress and traction, contact
with sharp edges, or other things that could damage the pipe.
9. Install quick ON – OFF valve between the gas mains and each single appliance where easy to reach.
10.After install Gas Wok Ring Table safely, take a pressure test the whole gas circuit by using leak finder spray
or non-corrosive foams.
11.The Gas Wok Ring Table is equipped with ISO 7/ 1 screw thread, gas connection of ¾ inches diameter and
suitable adapter for ISO 228/ 1 G screw thread gas connection are provided together with the appliance
according to destined countries.
