11
Body fan
Operation and Service KBL 6800/6900
aquaCool
Off
ON
Facial tanner/
Shoulder tanner
The control of the shoulder tanner is coupled to the facial tanner.
The shoulder tanner is switched on whenever the facial tanner is
activated but its power cannot be turned down. As soon as the facial
tanner is switched off, the shoulder tanner is turned off as well.
Important: Do not operate the shoulder tanner without lamp
unit.
Level II Once the tanning program has been started, the facial
tanners are automatically switched on at maximum
setting.
Level I To reduce the output to level I, use the !eld “–”.
Level 0 To switch off the facial tanners completely, touch the “–”
!eld again for at least 3 seconds. By touching the “+” !eld you
can switch the facial tanners on again or you can increase their
output. When the system has been switched off, there will be a
time lag before you can switch it on again due to the necessary
cooling of the burners.
The power of the body fan can be increased or reduced by
steps of 10 % by touching the !elds „+“ or „–”.
When switching the system on, the value is 60 %. (see Section
8 „Service“ of this manual)
When changing the value, the current setting is displayed as a two-
digit number between “20%” (minimum) and “99%” (maximum) in
the numerical !eld for a short time. In order to switch off the body
fan completely
, press the “−" field several times until the value of
20% appears.
Here you can activate the aquaCool water-atomisation function
(plus button, symbol fl ashes) or deactivate it (minus button, sym-
bol does not fl ash). Default setting at start: as defi ned on service
level I in the AAC/Aqua menu.
• If the aquaCool supply is running low, the message Aqua low
is shown on the display between the tanning sessions. When
the message appears for the fi rst time, the aquaCool supply will
last approx. another 2.5 hours of operation with aquaCool.
• If the aquaCool supply is empty, the message Aqua 0% ap-
pears and the symbol is crossed out. If the system is to be
used without aquaCool, you can switch off the messages and
the symbol. For this purpose, set the submenu Aqua to “OFF”.
To reach this menu, proceed to the AAC menu on service level
II.
Water tank is
empty
