WES Mesh Wireless System Operations Manual
WIRELESS ETHERNET MESH NODE DETAILS (CONTINUED)
OUTDOOR SINGLE RADIO NODE (MESH-A-Ox & MESH-B-Ox)
POWER INJECTION MODULE (PIM)
Note: The Power Injector Modules are not weatherproof units and must be protected from moisture.
PIM DESCRIPTION
A.
FRONT VIEW
PoE NOTIFICATION
The Mesh nodes are mid-span compliant and must be powered using
the supplied power injection module. If an 802.3af compliant PoE switch
is used, connect to a non-PoE port of the switch only.
5
WES Mesh Wireless System Operations Manual
MESH CONNECTION DIAGRAM
The following wiring schemes represent the configuration that has been tested and
verified by KBC based on typical Ethernet wiring solutions. Other wiring configurations
could be possible based on the application. A bench test is recommended to verify the
design below.
CONNECTING TO AN IP CAMERA
CONNECTING TO A KBC ENCODER OR DECODER
CONNECTING TO AN ETHERNET 10/100/1000 SWITCH
* Type of Ethernet cable is determined by the Ethernet device LAN
port. If the LAN port is a 10/100 port then the cable will be a crossover
cable. If the port is a gigabit connection then a straight-through cable
would be used. KBC recommends that both types of cables are on
hand in case your particular device requires a different configuration
than what KBC has tested.
6
A. FRONT VIEW
1
1.
Ethernet Port (not shown)
Seal with strain relief and
use outdoor rated cable
2.
Antenna Port
B. BOTTOM VIEW
1
2
1
2
3
1.
DATA IN – Connect to Ethernet Device
2.
POWER LED – Indicates power is on when lit
3.
P+DATA OUT – Connect to Mesh Node
1 3
2
Ethernet Cat5*
Straight-
through
Crossover cable
Data
In
P+Data
Out
12 VDC
PS
Straight-
through
Data
In
P+Data
Out
12 VDC
PS
12 VDC
PS
Straight-
through
Ethernet Cat5* Data
In
P+Data
Out
Note: Outdoor weatherproof tape
recommended over antenna port and
antenna connection at N-connector
1.
Ethernet Port (not shown)
Seal with strain relief and
use outdoor rated cable
2.
Antenna Port
