SEZIONE 3 - INSTALLATION AND START UP
3.1 Definitions
CUSTOMER
- The customer is the person, the agency or the company, that has acquired or rented the unit and that uses it for the conceived
purpose.
USER / OPERATOR
- The operator or user is the physical person who has been authorised from the customer to operate with the machine
SPECIALISTIC STAFF
- Intended are all those physical persons who have achieved a specific training, are therefore in a position to recognize
the dangers deriving from the use of this machine and are able to avoid them.
3.2 Safety Standards
The Manufacturer/Distributor Company declines whichever responsability for the non observance of the emergency and prevention norms
described below.
It declines furthermore responsibility for damages caused by an improper use of the unit and/or by modifications carried out without authoriza-
tion.
• The installation must be carried out by expert and qualified staff.
• During installation operations, use suitable accident-prevention clothing, as an example: glasses, gloves, etc as indicated by the 686/89/EEC
and successive norms.
• During installation, operate in absolute safety, in clean surrounding and free from impediments.
• Respect the laws in force in the Country in which the unit is installed, concerning the use and the disposal of the packings and the products
used for cleaning and maintainig the machine and follow the manufacturer instructions of such products.
• Before putting the unit in function, check the perfect integrity and safety of all components and of the entire system.
• Avoid at all cost to touch the parts in motion or to intefere with the same ones.
• Do not proceed with cleaning or maintenance operations, before switching off the electric power supply.
• The maintenance and the substitution of damaged or worn out parts of the unit must be carried out by qualified staff only and following the
indications contained in this handbook.
• Spare parts must correspond to the requirements defined by the Manufacturer Company.
• In case of dismantling of the unit, follow the relevant antipollution norms.
N.B. When using the unit, the installer and the user must take into account and place remedy to all the other types of risk connected with the
sistem. As an axample risks deriving from entry of foreign bodies, or risks deriving from the conveying of dangerous gases that are inflamma-
ble or toxic at high temperature.
3.3 Preliminary operations
.
• Check the perfect integrity of all components.
• Check that in the packing all the accessories for the installation and the relevant documentation, are included.
• Transport the packed section as close as possible to the installation place.
• Do not put tools or weights over the packed unit.
3.4 Choice of the installation place
• Place the unit on a solid structure that shall not causes vibrations and that is solid enough to support the weight of the machine.
• Do not place the unit in rooms where inflammable gases, acids or aggressive and corrosive substances may be present. These could dama-
ge the different components in an irreparable way.
• Foresee a minimum free space as shown on the following figures, to make possible the carrying of scheduled and not scheduled maintenan-
ce; in order to do maintenance to BIOX-DX system, allow accessibility from lower side around supply section with DX coil.
pag.
1
0
Содержание KRE-500DX1
Страница 1: ...KRE 500DX1 KRE 1000DX1 INSTALLATION USER MAINTENANCE MANUAL Cross flow heat recovery...
Страница 32: ......