Kaysun KCCHT-02, Руководство пользователя, Страница: 14 / 20

11
2) ADDRESS setting function
The address of wire controller can be set by pressing this button. The address range 0~15, therefore, 16 wire
controller could be parallel at most. Operation method: Press “AUXILIARY” “►” two button for 3 seconds to
enter the wired remote address selection. Press “ ◄ ” or “ ► ” key to select the desired value. 7S key operation
or press “OK” key to exit and save the settings and return Page. Not saved during set up, press the Cancel
key parameters and exit.
NOTE
When there is only one wire controller, it is necessary to execute this setting, the address of wire
controller should be set to ‘0’(main wire controller).
3) The fault is cleared
This feature can clear the fault and protection has been ruled out. Methods of operation: press the “AUXILIARY”
“
t
” two button for 3 seconds to clear the fault. Page of the main page and Inspection press this key combination,
you can clear the entire system fault, the fault code cleared at the same time.
Fig.4-10
Fig.4-11