29
2022_001
4.2 To charge the battery
Warning!
Do not connect the charger to a power
source if it is not connected to the battery.
●
The battery is half-charged when it is new. Charge the
battery for 10-12 hours the first 3 times.
●
Charge the battery when the battery charge is low.
●
Charge the battery for at least 2 hours every 3 months.
Failure to do this will invalidate the warranty.
●
Protect the battery from contact with liquid or metal
objects.
●
Do not turn or move the charger or the battery during
charging.
●
When the battery is fully charged, disconnect the charger
from the mains outlet before you disconnect the battery
from the charger.
●
Do not charge the battery through the discharging
terminals.
●
Do not discharge the battery through the charging
terminals.
●
The charger is for indoor use. It must only be used in a
dry area with god air flow. Make sure that the
temperature is 0-45°C when the charger is used.
●
Make sure that the temperature is -20-+45°C and the
relative humidity is ≤ 80%, when the battery is
discharged.
●
Follow the instructions on the marking on the battery.
●
Put the charger 1 m from electrical equipment such as
computers, television and receivers, when in use.
●
Disconnect the charger if there is an abnormal smell.
4.2.1 To charge the battery on the bike
1
Connect the charger to the outlet on the battery.
(Figure 5)
2
Connect the charger to a power source.
4.2.2 To remove the battery from the bike and
charge it.
1
Press the On/Off button on the control panel to stop
the power assistance.
2
Press the On/Off button on the battery to turn the
battery off.
3
Turn the key lock on the battery (A) and pull back the
battery to release it from the bike (B). (Figure 6)
4
Connect the charger to the outlet on the battery.
5
Connect the charger to a power source.
4.2.3 The charge indicator
●
The light on the charger is red when the battery is
charged.
●
The light on the charger is green when the battery is fully
charged.
●
The light on the charger flashes if there is a fault. Speak
to an authorized service center.
4.3 The power assistance
●
Stop the power assistance if the product behaves
abnormally.
●
Press the Mode button to adjust the assistance level.
●
The power assistance stops at 25 km/h.
●
When the speed drops below 25 km/h and the rider
continues to pedal the power assistance starts again.
●
The electrical system has a low voltage protection. The
power assistance stops when the battery has low power.
4.3.1 To start the power assistance
1
Press the On/Off button on the battery to start the
battery.
2
Press the On/Off button on the control panel to start
the power assistance.
3
Start to pedal to activate the motor.
4.4 The brakes
Warning!
Do not use a product with brakes that do
not operate correctly.
●
The bike has a rim brake that controls the rear wheel.
●
The bike has a brake handle that is located on the left
side of the handlebar. The brake handle controls the front
wheel.
