EN
46
5. Plug the charger into a power point.
WARNING!
Do not connect the charger to a power point
if it is not connected to the battery.
Charge indicator
• The charger light turns red while charging
is in progress.
• When the battery is fully charged the
charger light turns green.
• A flashing red and green light indicates a
fault. Contact an authorised service
centre.
MAINTENANCE
WARNING!
The battery must not be mounted on the bike
during maintenance or repairs.
GENERAL
• Use a sponge moistened with a mild
detergent when cleaning. Do not use
acidic detergents, they can damage the
bike.
• Avoid leaving the bike unprotected in the
rain or snow.
• If the bike gets wet, wipe it with a towel
after use.
• If the bike is used on a salted surface,
clean it after use with fresh water.
• Do not clean the bike with a high-pressure
washer – risk of water and moisture
penetrating into the electrical
components and motor.
REGULAR MAINTENANCE
Run the following checks at intervals of 1 to 2
months:
• Check that the stem, handlebars and
saddle post are correctly fitted and
tightened.
• Check that the axle nuts on the wheels are
correctly tightened.
• Check that the rims are not cracked and that
the spokes are in good condition and well
tensioned.
• Check that the tyres are not worn or
damaged.
• Check that the tyre pressure is correct.
• Check that the battery contactors on the
frame are clean and free from oxide.
• Check that the battery is sufficiently charged.
• Check that the lights are working properly.
• Check that the front and back brakes are
working properly.
• Check that the wires are well lubricated and
that the brake pads are in good condition.
• Check that the welds on the frame are in
good condition and free from rust.
SPOKES
Spoke tension
The spokes should be equally tensioned round
the wheel.
1. Check the spoke tension by squeezing two
adjacent spokes on the same side of the
wheel together.
2. Go round the wheel to check if any spokes
are loose.
3. Check that the rim is not warped by
turning the wheel and using the brake
pad as a reference point.
4. Tension loose spokes with a spoke key. If
you are not sure how to do this, take the
bike to an authorised service centre to
tension the spokes.
Содержание 005018
Страница 4: ...1 2 1 2 3 9 12 11 10 23 22 8 7 21 6 5 4 20 19 18 17 16 15 14 13 1 4 3 2 6 KM H...
Страница 5: ...3 4 2 3 1...
Страница 6: ...5 6 7...
Страница 7: ...11 8 9 10...