16.Install the front wheel on the front hub, use
tools
①⑥⑧
to tighten the bolts(H) (torque
requirements 25-30N.m)
17.Align the rear wheel with the splines and push
on the rear axle, with the air nozzle cap facing
outward. Put the washer first then the nut(C), use
tools
①⑥⑩
to lock and insert the cotter pin, keep
the bending angle greater than 180° (torque
requirement 77-92N.m)
18.Insert the dust cover(M) into the positions
shown above.
19.Pull the latch as above shown and remove the
seat cushion, waiting for the subsequent
installation of the battery.
20.Put in the battery and install the fixing
bracket(I), use tool
⑫
to tighten the bolts.
21.Connect the positive and negative poles as
shown above, use tool
⑪
to tighten the bolts and
re-install the seat.
Note: red is positive, black is negative.
