8. Use tool
⑦
to tighten the rear reflector bracket
bolt (T).
9. Use tool
⑦
to install the combination switch
10. Use tool
⑩⑫
to remove the screws fixed on the
rear axle, and then use tool
⑧
to remove the
screws fixed to the front of the frame (The front
frame fixing wire is a temporary solution, and the
subsequent packaging is fixed with bolts)
11. Put the vehicle on the stand for easy
installation of other accessories.
12. Use tool
①⑫⑯
to tighten front fork bolt and
nut(L).
(torque requirement 49-59N.m)
13. Install the pull rod
on the steering knuckle, then install slotted nut
and washer(K). Use tool
①④
to tighten, and
insert the cotter pin(K), the bending angle is
greater than 180°(torque requirement
49-59N.m)
Содержание A180
Страница 1: ...KAYO MOTO A180 Assembly Manual WWW KAYOMOTO COM...
Страница 2: ......
Страница 9: ......