Kayden CLASSIC 810, Руководство по эксплуатации продукта

Страница: 33 / 72

25
Shop Online
CLASSIC 800 Product Manual
Setup & Operation
6. View or Adjust the Node Address & View the Software Revision
The Software Revision and Node Address are displayed on the Thermal Signal Bar Graph as two binary bytes.
The Software Revision is not adjustable but can be useful should telephone support be required.
The Factory Default for the Node Address is 1 (one).
Adjusting the Node Address is only required if setting up a multi-point RS-485 network or adding the CLASSIC
800 to an existing RS-485 network.
The Software Revision and Node Address can also be viewed while in
Run Mode by pressing and holding the
RUN key.
To View or Adjust the Node (Unit) Address:
1. Press and release SET until the Relay 2 LED is flashing AND the Run Mode LED is off.
2. The Thermal Signal Bar Graph now displays the value of the Software Revision and the setting
of the Node Address.
3. The Node Address is displayed in binary using the eight LED’s on the righthand side of the Bar Graph.
Refer to Section 6 “Binary Table” , for a listing of Node Address to LED patterns.
4. To adjust the Node Address, press and release the Left and Right Arrow keys.
5. When satisfied with your configuration, press and release SET to continue to the next programmable
variable or press and release RUN to return to Run Mode.
Figure 20 - Software Revision & Node (Unit) Number
Thermal Signal
100%
0
Relay 1
Relay 2
Fault
Set Point 1
Set Point 2
Run Mode
Bypass
RUN
SET
1 2
CLASSIC
™
Software Revision
Node or Unit Number