High Speed Camera User Guide
16
The first stage of the system installation is Komodo board installation as described in section 6.2.1
below. The second stage is connection of the camera as described in section 6.2.2.
6.2.1
Komodo board installation
Before system installation the Komodo board should be installed into the host computer. Komodo
board is standard PCIe card with 8 lanes connector.
It can be installed in any PCIe connector of the motherboard with 8 lanes and up.
Note:
Board should be installed before you install your software.
1.
Before installing, turn off the power of the computer and its peripherals.
2.
Firmly insert the Komodo board to PCIe connector of the motherboard.
3.
Anchor the PCIe bracket to the computer chassis using M3 screw.
4.
Verify the Komodo board inserted correctly to the PCIe slot.
5.
Power up the computer.
6.
After OS is up, you will be asked to install a driver for new Multimedia Device.
At this stage, you should cancel the installation.
Under Windows and Linux the compatible drivers for Komodo board will be installed during
installation of Vision Point App software.
You can install and use multiple Komodo boards in a single computer.
The number of Komodo boards that can be installed in a computer depends on the number of
available PCIe slots.
For more information please refer to Vision Point Software Installation Guide documentation.
6.2.2
Completing the JetCam installation
In order to properly complete the
JetCam
system installation, the following steps must be taken for
initial power up:
a.
Make sure there is no dirt or any other foreign matter inside the QSFP+ module, or blocking
any of the connectors.
b.
Make sure that the male connectors on the QSFP+ module will align with the female
connectors inside the cage.
c.
Insert the QSFP+ modules into the
JetCam Camera and Komodo Fiber board
and close the
locking mechanism (*).
Installation and Configuration