31
M
ain
O
pe
ra
ti
on
Amp Simulator parameters
Page
Knob Parameter
Description
Value range
1
A
Amp Type
Changes the type of amplifier model.
[see table above]
B
Drive
Adjusts the drive level of the amplifier.
0 ~ 127
C
Level
Adjusts the overall volume level of the amplifier.
0 ~ 127
2
A
Amp EQ Lo
Adjusts the gain of the amplifier’s low frequencies.
–10 dB ~ +10 dB
B
Amp EQ Mid
Adjusts the gain of the amplifier’s mid frequencies.
–10 dB ~ +10 dB
C
Amp EQ Hi
Adjusts the gain of the amplifier’s high frequencies.
–10 dB ~ +10 dB
D
Mid Frequency Adjusts the frequency of the amplifier’s mid-range band.
200 Hz ~ 3150 Hz
3
A
Mic Type
Changes the type of microphone used for the amplifier.
Condenser, Dynamic
B
Mic Position
Change the position of the microphone used for the amplifier.
OnAxis, OffAxis
C
Ambience
Adjusts the mixing ratio of additional ambient microphones.
0 ~ 127
Adjusting additional Amp Simulator parameters
Press and hold the MAIN zone’s AMP button, then press the F1
FUNCTION button (corresponding to the selected MAIN zone).
The second AMP page of the EDIT menu will be shown in the
LCD display.
Page 2/3
arrow:
Next page
Turn the control knobs (A, B, C, D) to adjust the amp simulator’s
Lo, Mid, Hi, and MidFreq EQ parameters.
Press the F1 button again.
The third AMP page of the EDIT menu will be shown in the LCD
display.
Page 3/3
arrow:
Next page
Turn the control knobs (A, B, C) to change the type and
positioning of the amp simulator’s microphone, and adjust the
ambience parameter.
Amp EQ Hi
Amp EQ Lo
Mid Freq.
Amp EQ Mid
Ambience
Mic Type
Mic Position
hol
d
Effects Section