Operating Manual
16
Original Operating Manual
6.3
Schedule for routine maintenance and lubricants
Lubricants approved and recommended by KAUP
Greases
Note
Lithium soap grease
NLGI Class 2
e.g. Avialith 2
Designation DIN51825:
K 2 K-30
Complex soap grease
NLGI Class 2
e.g. Turmogrease Gel M 5
Foundry quality
Teflon spray
e.g. Wieds or Rivolta
Only for plastic sections
The specified maintenance schedules can change as a result of the operating conditions
such as extreme cold, heat and dust or poor ground conditions and this must be taken
into account by the owner.
With other loads, such as fork arms with a length of over 2,400 mm or raised load
centres, amended/shorter maintenance intervals should be agreed by the user with the
manufacturer.
6.3.1 Pressure plate
Daily
Ensure that the screw (1) with plain washers (10) is mounted and tightened. This
screw is used as a limit stop and prevents uncontrolled moving out of the slide (2).
As necessary
Renew worn pressure plate linings (3) or damaged pressure plates (4) by removing
the screw (5) and washer (6) on the bearing pin (7). Pull the bearing pin (7) out to the
side. Demount screw (9) with washer and replace worn or damaged parts.
Afterwards, mount the screws (9) with washer, and bearing pin (7) with washers (6, 8)
and screw (5).
7
8
5
6
1
10
2
4
9
3