8
Next, locate the Reed Switch (49). Turn the Crank
(22) until the Magnet (4) is aligned with the Reed
Switch. Loosen but do not remove the M4 x 16mm
Screw (46). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Turn the
Crank for a moment. Repeat until the console dis-
plays correct feedback. When the Reed Switch is cor-
rectly adjusted, reattach the left side shield and pedal.
HOW TO ADJUST THE RESISTANCE STRAP
If there is not enough pedaling resistance when the
resistance knob is turned to the highest setting, the
Resistance Strap (15) may need to be adjusted. To
adjust the Resistance Strap, the left side shield must
first be removed. Refer to the instructions on page 7
and remove the left side shield.
Next, turn the
resistance knob
to the lowest set-
ting. Locate and
open the Strap
Clamp (38). Grip
the end of the
Resistance Strap
(15) and pull it up
slightly. While
holding the end
of the Resistance
Strap,
fully
close the Strap Clamp. Turn the Crank
(22) for a moment to make sure that there is not too
much resistance. When the Resistance Strap is prop-
erly adjusted, reattach the left side shield and pedal.
HOW TO ADJUST THE DRIVE BELT
The exercise cycle features a drive belt that must be
kept properly adjusted. If the belt causes excessive
noise or slips as you pedal, the belt should be
checked. To do this, the side shields must first be
removed. Refer to the instructions on page 7 and
remove the left side shield. Next, remove the right
side shield in the same way.
Press down on
the center of the
Drive Belt (14)
between the front
and rear pulleys.
There should be
from 1/4Ó to
1/2Ó of move-
ment in the cen-
ter of the Belt.
If the Drive Belt
(14) is properly
adjusted, reat-
tach the side
shields and ped-
als. If the Belt
needs to be
adjusted, loosen
the Nylon
Locknut (7) on
the left side of
the Flywheel
(29). To tighten the Belt, turn the M10 Nut (30) clock-
wise; to loosen the Belt, turn the M10 Nut counter-
clockwise. Make sure that the Flywheel is straight and
tighten the Nylon Locknut (7). Reattach the side
shields and pedals.
4
22
30
14
Top View
Top View
14
7
29
49
22
46
38
15
