27 of 40
27 of 40
Move Steps [1]
East
Rotates the polar antenna step by step towards the
East (clockwise) until Stop is selected.
West
Rotates the polar antenna step by step towards the
West (anti-clockwise) until stop is selected.
Stop
stops the rotational movement.
Go to XX(-7.5)
3)
Move the satellite that is named under
Satellite
. This is based
on the USALS Setup described under
4.3.6, P. 28
.
Limit Set
East Stop
sets the current position of the polar antenna as
the East limit (= clockwise stop)
4)
.
West Stop
sets the current position of the polar antenna as
the West limit (= anti-clockwise stop)
4)
.
Ref Position
Moves to the reference satellite that was used for calibration
when the turntable was installed
5)
.
Reset-Calculate
Deletes the position of the reference satellite and also the
values for the East and West stops (see
Limit Set
)
4) 5)
.
Deletion is recommended before connecting the receiver to a
different turntable.
Store Position
Stores the position of a satellite that has not yet been saved.
1)
Signal strength and quality appear in the lower screen area.
2)
USALS
corresponds to DiSEqC 1.3
3)
Only if
Motor
=
USALS
4)
The receiver automatically calculates the positions of the satellites from the position of the reference
satellite and the values of the East and West stops.
5)
When calibrating the reference satellite, refer to the documentation for your polar antenna.
