Kathrein UFM 341, Инструкция по эксплуатации

Страница: 6 / 16

Setup Instructions
The TV modulator is set up via the controller on the base unit UFG 3xx.
Required central controller software version: at least version 8.10
For setup connect the controller to the module.
The buttons listed in the following relate to the controller (refer also to the operating instructions for the corresponding
base unit UFG 3xx).
Note:
The settings and numerical values shown in the following are presented by way of example, and do not necessarily
represent the condition of the TV modulator when shipped.
936.2825/-/1005/.4
e
Select the desired parameter using the “←” and “→” buttons. The selected parameter fl ashes on the display.
Use the “+” and “-” buttons to make the setting .
Finally, press “ M ” to save the setting in the module. If the controller is disconnected from the
module without saving the settings, the settings originally stored in the module are reactivated.
1 Selecting the output frequency and output channel
Outp. C 69 855.25 MHz
Stereo RF on
Main menu Output sub-menu
You can use the “+“ and “-“ buttons to adjust the channel continuously from 48.25 to 62.25 MHz and 111.25 to 847.25 MHz in
7 or 8 MHz steps
(according to the standard); the channel is only displayed where applicable .
You can fi ne-adjust the output frequency in 250 kHz increments on the output channel’s sub-menu .
Press the “(sub-menu)” button to switch to the sub-menu and use the “+” and “-” buttons to set the required frequency.
Then press the “(sub-menu)” button to exit the sub-menu.
2 Selecting the output level
Outp. C 69 855.25 MHz
Stereo RF on
Main menu Output sub-menu
You can use the “+“ and “-“ buttons to adjust the output level continuously in 40 steps.
The setting limits are marked “ min ” and “ max ” (comparable to the left and right stop limits of a conventional
attenuator).
You can set the output level in the output channel’s sub-menu .
Press the “(sub-menu)” button to switch to the sub-menu and use the “+” and “-” buttons to set the required level.
Then press the “(sub-menu)” button to exit the sub-menu.
*** UFM 341 ***
Freq. 855,25 MHz
level -10 Standard B/G
*** UFM 341 ***
Freq. 855,25 MHz
level -10 Standard B/G