Basic Setting-up
21
Basic Setting-up
The ”Basic Setting-up” menu enables you to connect the receiver to the satellite
reception system.
Important
The receiver has already been pre-programmed by the manufacturer as a standard
satellite receiving system.
Changes to the basic setting-up are only required if your receiving equipment is
non-standard or you wish to use a non-standard reception system.
These menu settings are normally made by the qualified technician during the ba-
sic installation of the satellite reception system.
To prevent unintentional changes to the basic setting-up, the basic setting menu
can only be called up when the receiver is first switched on, (remove the power in-
put).
Calling-up the Basic Setting-up Menu
•
Remove the power plug from the socket in the(Innenhohlleiterstecker) (6) bay.
•
Press and hold down both program selection
buttons (4) simultane-
ously on the infra-red sensor.
•
Re-insert the plug back into the socket.
•
Release both
buttons when the LCD-display shows the following:
>OSD language:
„
„
GERMAN
LNB voltage-supply
ON
-at Stand by-:
OFF
Program selection:
FREE
OSD:
OFF
ADR scan . . .
Oscillator menu . . .
DiSEqC menu . . .
EEPROM . . .
VOL 0-9 A/B STOR STBY
The status line at the bottom of the menu shows the buttons that you must use to
change the settings.
The settings in the basic setting-up menu are made in exactly the same way as in
the previous TV and radio menus:
•
Use these
buttons to select the menu option.
•
Make selection and call-up sub-menus with these
buttons (and the
number buttons
for entering the frequencies).
•
Press this
button
twice
, to save your settings.
•
Exit with this
button.
OSD Window Language
You may select your language using the
O
n-
S
creen-
D
isplay window.
The choice is between German, English or French.
Default setting:
German
