Kathrein HDP 600, Руководство по установке

Страница: 8 / 20

8
IMPORTANT INSTRUCTIONS/ COMPONENTS AND SCOPE OF SUPPLY
1. Roof gland with retaining nut
2. Mounting plate for the HDP 600
3. Turntable with integral controls
4. Antenna
boom
5. Mounting plate for the BAS 60
6. 2 screws for securing the BAS 60
The installation of the HDP 160 should always be performed by a specialist (e.g. the
caravan dealer). Improper installation will render the warranty void.
Make sure that:
- The antenna and connected units are disconnected from the power
- The person carrying out the installation does not suffer from vertigo and can move around safely on the
roof of the caravan or motor home
- The person carrying out the installation is wearing sturdy non-slip shoes
- The person carrying out the installation has a secure position to stand and hold on while working
- The roof and the climbing equipment used (e.g. ladder) are dry, clean and non-slip
- The roof can withstand the weight of the person carrying out the installation
Caution! Risk of death or injury due to falling or roof collapsing!
- No persons, especially small children, should be in the immediate area of the turntable or antenna and
touch movable parts during installation/deinstallation of the turntable and planar antenna. Nobody should
be below the antenna inside the caravan / motorhome during dismantling / installation.
Caution! Risk of death or injury due to possible roof collapsing and falling parts on the motor
home/caravan
Note also the chapter “Important safety instructions” in the CAP 600 installation and operating
instructions!
Make sure the antenna has a clear unobstructed swing path (see “Important safety instructions”
in the CAP 600 installation and operating instructions)!
Items supplied:
•
Turntable complete with control electronics (3. and 4.)
• Mounting plates (2. and 5. - one each for the HDP 600
and BAS 60)
• Two screws for securing the BAS 60 to the
HDP 600 (6.)
• Complete cabling set: 1 x coax cable 8 m long, and
one power supply cable (10 m) for connection to the
on-board power supply
• Roof gland with sealing gasket (1.)
• Sikafl ex
®
291 adhesive sealant (100 ml tube)
• MobiSet 2 digital CAP 600 installation and operating
instructions
• Installation instructions HDP 600 (+ installation
BAS 60)
• Safety instructions for lowering the antenna whilst
driving
COMPONENTS AND SCOPE OF SUPPLY
6
.